DCL 571

DCL 571 ceramic sensor
with RS485 Modbus RTU
  The stainless steel probe DCL 571 with RS485 interface uses the communication protocol Modbus RTU which has found the way in industrial communication as an open protocol. The Modbus protocol is based on a master Slave architecture with which up to 247 Slaves can be questioned by a master – the data will transfer in binary form.
  It was developed for level measurement in waste water, sludge or water courses. The mechanical robustness of the flush ceramic diaphragm facilitates an easy disassembly and cleaning of the probe in case of service.
  Compared to the level probe DCL 551 the outside-diameter is only 22 mm, which allows an easy installation and back fitting in 1“ tubes or in cramped fitting conditions.
Features nominal pressure: 0 … 1 mH2O up to 0 … 100 mH2O
  output signal: RS485 with Modbus RTU protocol
  diameter 22 mm
  excellent long term stability good long term stability
  highly appropriated for sewage water
Optional Features Drinking water certificate acc. to DVGW and KTW